The Geneos X Broadcast plug-in monitors (UDP) broadcast traffic and displays statistics such as the data rate and packet rate, for a list of user-defined services.
The Netprobe host must be able to "listen" for the required broadcast traffic (i.e. it should be on the same network segment as the broadcast source).
The X Broadcast plug-in produces a single view, with one row per configured broadcast service.
|name||The service name, as configured by the user.|
|port||The service port, as configured by the user.|
|dataRecvRate||Data received in Kb/s, averaged over the sample interval.|
|pktRecvRate||Packets received per second, averaged over the sample interval.|
|tmSinceLastPkt||Number of seconds since the last packet was received.|
|srcHost||The IP address of the host which sent the last packet.|
The X Broadcast plug-in listens to all broadcast data, matching the destination ports with those configured by the user.
Plug-in configuration is placed in the x-broadcast configuration section.
Specifies a comma-separated list of network interface names to monitor broadcast data on.
On UNIX machines, interface names can be found using the command "ifconfig -a". Example names are "eth0" or "ce0".
On Windows machines, interface names can be listed by running Netprobe using the "-ifconfig" command-line option. A Windows interface name will look similar to the following:
The name of the broadcast session - this is the name which will be displayed in the view (as the row name). Session names should be unique within each plug-in instance.
The plug-in requires the netprobe to be run with root permissions (on Unix operating systems) or as a local Administrator on Windows, as it needs to open network devices.
On Linux kernel versions 2.6.24 and up, an alternative to running the netprobe as root is available: Set the CAP_NET_RAW and CAP_NET_ADMIN Linux capability on the netprobe binary with the command "setcap cap_net_raw,cap_net_admin+eip <netprobe binary>" replacing <netprobe binary> with the appropriate netprobe binary file such as 'netprobe.linux_64'.
When running the netprobe with set capabilities, the lib64 folder in the netprobe directory should be put in the ld.so trusted paths. Otherwise, the runtime libraries will not be loaded properly. For guidance, see Run Netprobe under elevated privileges in Linux in Quickstart: Linux and other platforms.
On Solaris an alternative is to run the netprobeGXL program available from ITRS Support. This program is an auditable utility which runs as setuid root. The purpose of this program is to open the network device which is then passed to Netprobe, so that Netprobe does not need to run as root.
Windows: The Winpcap packet capture library (http://www.winpcap.org/install/default.htm) needs to be installed on the host. Version 4.0.2 is required for Windows Vista/Server 2003 support.
Unix: The shared library libpcap.so (version 1.0.0 or later is recommended) needs to be in the netprobe lib64 directory.
Note: As the netprobe needs to be run as root the LD_LIBRARY_PATH is ignored for security reasons.