The Geneos X Mcast plugin monitors multicast traffic and displays statistics such as the data rate and packet rate, for a list of user-defined multicast groups.
This plugin differs from the X Multicast plugin in that it can monitor for multicast data without necessarily subscribe for it, and also does not need to read and discard data so is slightly more efficient.
The Netprobe host must be able to "listen" for the required multicast traffic (i.e. it should be on the same network segment as a host already subscribing to the required multicast data).
The X Mcast plugin produces a single view, with one row per configured multicast session.
|totalDataRecvRate||Data receive rate for all monitored sessions.|
|totalPktRecvRate||Packet receive rate for all monitored sessions.|
|name||The session name, as configured by the user.|
|port||The session port, as configured by the user.|
|dataRecvRate||Data received in Kb/s, averaged over the sample interval.|
|pktRecvRate||Packets received per second, averaged over the sample interval.|
|tmSinceLastPkt||Number of seconds since the last packet was received.|
|srcHost||The IP address of the host which sent the last packet.|
The X Mcast plugin listens to all multicast data received by a host, matching the destination host and ports with those configured by the user.
Plugin configuration is placed in the x-mcast configuration section.
Specifies a comma-separated list of network interface names on which to monitor multicast data.
On UNIX machines, interface names can be found using the command "ifconfig -a". Example names are "eth0" or "ce0".
On Windows machines, interface names can be listed by running Netprobe using the "-ifconfig" command-line option. A Windows interface name will look similar to the following:
Specifies the list of (at least one) multicast sessions that this plugin will monitor.
The name of the multicast session - this is the name which will be displayed in the view (as the row name). Session names should be unique within each plugin instance.
The plugin needs to open network devices, so you should run the Netprobe using root or administrator permission on and , respectively.
On Netprobe as root is
by setting the
CAP_NET_ADMIN capabilities on the Netprobe binary using the following command:
setcap cap_net_raw,cap_net_admin+eip <netprobe binary>
When running the Netprobe with set capabilities, the
lib64/startup folder in the Netprobe directory should be in
ld.so trusted paths. Otherwise, the runtime
libraries will not load properly. For guidance, see Run Netprobe under elevated privileges in Linux in Quickstart: Linux and other platforms.
: The Npcap packet capture library needs to be installed on the host. If Npcap is not installed using WinPcap API-compatible mode, then the Npcap installation directory must be added in the
PATH environment variable or the
DLL_PATH registry variable.
: The shared library
libpcap.so needs to be in the
netprobe/lib64 directory. It is recommended to use
libpcap.so version 1.0.0 or later.
Note: As the Netprobe needs to be run as
LD_LIBRARY_PATH is ignored for security