URL parameters

Opsview Monitor allows the use of a couple of parameters in the URL to access some pages directly. These are as follows:

autoSelectHost Copied

Example: http://opsview/monitoring/#!?autoSelectHost=Opsview

This parameter will open the monitoring navigator page with the named Host selected, so all of the service states are shown within the checker at the bottom of the page

autoSelectService Copied

Example: http://opsview/monitoring/#!?autoSelectHost=Opsview&autoSelectService=Disk: /

Note

This must be used in conjunction with autoSelectHost.

This parameter will open the Info tab in the Investigate modal for the named Service Check on the Host.

["Opsview"] ["User Guide"]

Was this topic helpful?