Detail - Setting

Note

Setting a service check to enter a soft state before transitioning to a hard state based on recheck attempts is no longer supported via the REST API. Service checks now transition directly to a hard state. Additionally, the state_type parameter is no longer a valid input in the Detail - Setting for services.

You can choose hosts or services using the same URL parameters as the status API.

Input:

{
 "notifications": { "enabled": 0 }
}

Output:

{"success": "1"}

Possible input values for host:

{ 
 "active_checks": { 
  "host_enabled": 0, // or 1
  "services_enabled": 1 // or 0
 },
 "passive_checks": {
  "enabled": 0, // or 1
 },
 "set_state": {
  "result": 0, // 0=UP, 1=DOWN, 2=UNREACHABLE
  "output": "Plugin output|time=9", // Must be set not empty. Add perfdata after pipe symbol
 },
 "notifications": {
  "host_enabled": 0, // or 1
  "services_enabled": 0, // or 1
 },
 "event_handler": {
  "enabled": 0, // or 1
 },
 "flap_detection": {
  "enabled": 0, // or 1
 },
 "recheck": {
  "check_host": 0,       // or 1. If both are 0, then nothing is sent to the Orchestrator
  "check_services": 0, // or 1
  "time" : 1234567890, // Epoch seconds. Default now
 }
}

Possible input for services:

{ 
 "active_checks": { 
  "enabled": 0, // or 1
 },
 "passive_checks": {
  "enabled": 0, // or 1
 },
 "set_state": {
  "result": 0, // 0=OK, 1=WARNING, 2=CRITICAL, 3=UNKNOWN
  "output": "Plugin output|time=9", // Must be set not empty. Add perfdata after pipe symbol
 },
 "notifications": {
  "enabled": 0, // or 1
 },
 "event_handler": {
  "enabled": 0, // or 1
 },
 "flap_detection": {
  "enabled": 0, // or 1
 },
 "recheck": {
   "time" : 1234567890, // Epoch seconds. Default now
 }
}

You can also set some input using parameters.

Valid parameters for hosts:

Valid parameters for services:

["Opsview On-Premises"] ["API", "Technical Reference"]

Was this topic helpful?